Brushless powered Glider factory fi tted 2.4GHz RadioASSEMBLY INSTRUCTIONSELECTRAGLIDE SPECIFICATIONS Wingspan: 1520mm (61”) Length: 920mm (36”) Wei
10 ElectraGlide Instruction ManualSWITCH ON THE TRANSMITTER21. The ElectraCam comes with an EScale 2.4GHz. Transmitter.22. Install 8-AA batteries (
11ElectraGlide Instruction Manual25. After turning ON the transmitter, remove the canopy of the ElectraGlide and place the ground. Locate the charge
12 ElectraGlide Instruction ManualTRANSMITTER LAYOUTMODE 2 TRANSMITTER LAYOUT29. Left Stick is Throttle (up and down) and Rudder (side to side)30. R
13ElectraGlide Instruction ManualCONTROL CHECKS44. Elevator is controlled by the elevator stick. Check that the direction and distance of movement is
14 ElectraGlide Instruction Manual51. Ailerons are controlled by the aileron stick. Moving the stick to the right, the right aileron should come up a
15ElectraGlide Instruction ManualPREFLIGHT CHECKSIf you are new to fl ying R/C aircraft, or even an experienced modeller, we recommend you have a fello
Brushless powered Glider factory fi tted 2.4GHz RadioJune 2010Australasian agents:Model Engines, Melbourne, Australiawww.modelengines.com.auEuropean ag
2 ElectraGlide Instruction ManualVITAL SAFETY INFO CAUTION! The ElectraGlide is not a toy. It can cause injury to persons/animals and/or property if
3ElectraGlide Instruction ManualKIT CONTENTSCONTENTS LIST 1 2.4 GHz 5ch EScale Transmitter 1 Fuselage with 2.4 GHz receiver, 4x 9g Servos, Brushle
4 ElectraGlide Instruction ManualLITHIUM POLYMER FLIGHT BATTERYThe Lithium polymer (Li-po) fl ight battery is a high power battery designed to give a fl
5ElectraGlide Instruction ManualCHARGING THE FLIGHT BATTERYThe charger is designed to automatically charge the Li-Po battery in about 1 hour from a di
6 ElectraGlide Instruction ManualASSEMBLING THE ELECTRAGLIDE5. Locate and test fi t the horizontal stabilizer and elevator to the fuselage.6. Peel th
7ElectraGlide Instruction Manual10. Connect the clear clevises to the elevator horn and rudder horn. Push the ends of the clevises fi rmly together t
8 ElectraGlide Instruction Manual14. This picture shows the wings with wire wing spar in place and servo leads connected15. Slide one of the wing pa
9ElectraGlide Instruction Manual17. To futher reduce sensitivity the wire may be moved to the inner holes of the servo horns. (Shown here on the el
Comments to this Manuals